Model 440
(Formally Model 420)

   A deluxe "non-hunting" pilot with full remote control. To be used with mechanical steering systems only. An ideal pilot for mechanical steering systems.

420 Configuration
Installed Model 440 Pilot
 Remote control from one or more stations
 Power steering
 Course changing (permanent or temporary)
 Maneuvering, circling and dodging without loss of automatic course or touching steering wheel or clutch
 Steering wheel moves only when vessel is off course
 Very accurate steering under all sea conditions, including following seas
 Low power drain enables use under sail as well as power
 Limit switch included
 Enclosed compass unit, flexible-shaft driven
 Positive action friction clutch
 Electro-dynamic braking system positively positions steering wheel; never needs adjusting for wear
 Fully Solid State Electronic Control Unit
 Available in 12, 24, and 32 volts DC or with rectifier unit (accessory) for use on 115-volt single-phase AC power input

Assembly #42000 - Model 440 includes:
 compass unit, completely housed
 Electronic Control Unit with cords (12 ft.)
 Motor unit
 Limit switch assembly (installed on motor unit)
 Sprocket - 50-tooth, 8-in. with hub 1/2" pilot bore
 Chain - 8-ft., #41 blued steel
 Flexible shaft and fittings, 6 ft. long (longer at extra cost)
 Magnets - 2 for compensating compass
 Installation and servicing instructions
Also available at extra cost, as accessories;
 Part #8200 - Remote Control handle (water resistent); 50-ft. cord standard
 Part #8102.2 - Junction box dual (for use with more than one remote)
Vessel Evaluation Sheet must be completed and returned when ordering via voicemail, e-mail or fax.

Shipping: All orders are shipped via Federal Express , F.O.B. Tacoma, Washington. Prepaid & Credit Card orders may ship via customer-requested carrier.

This site is copyright 2001 - 2002 MMP, Inc. all rights reserved
Please contact us at